The bench
Craftsmanship
Two watchmakers, a timing machine and a pressure tester. This is the part of the trade most sellers skip.
Four stages, no shortcuts
- Parts selection. Case, dial, hands and movement are inspected on arrival; anything with a finish defect goes back.
- Assembly. Hands set under a loupe, date wheel aligned, gaskets renewed, bracelet sized to your wrist measurement.
- Regulation. Rate, amplitude and beat error recorded in six positions. We hold builds to ±5 s/day before they leave.
- Pressure test. 5 bar for ten minutes, then a 24-hour visual check for condensation and hand drift.
“If the printout is wrong, the watch does not ship. It goes back on the bench.”
What travels with the watch
Documentation
Timing printout
Six-position rate sheet, signed with the build date and the serial we record against your order.
QC photographs
Dial, case flanks, clasp and caseback photographed under neutral light before packing.
Two-year warranty
Movement service covered for 24 months. Water ingress and accidental damage are quoted separately.